11
Subject to change without notice | 83057100hUK – Translation into English of the original German operating manual | ait-deutschland GmbH
6
Installation and connection
6.1 Dismantle the module box
ATTENTION
If the module box is tilted by more than 45°,
compressor oil runs into the cooling circuit.
J
Do not tilt the module box by more than 45°.
NOTE
O
If necessary the module box can be
dismantled for easier transport of the unit
or for service reasons.
O
Steps 1 to 5 are only required if the
').:*0$()\$/+$3)--0310.$,-.$2**0."
"
Unit is safely disconnected from the power
supply and protected against being switched
(,35$)-$,6,/-"
1. Remove the front panel of the module box
(
!
“7.1 Remove the front panel of the module
box” on page 16).
2. Close shut-off valves to the heating circuit.
3.
a4,/-$1B0$:-/1$D/,$1B0$2**/-6$,-.$.4,/-$1,?$)I$1B0$
heating.
4. Use a spanner to close the shut-off valves of the
heat source (behind the covers).
5.
a4,/-$1B0$:-/1$D/,$1B0$2**/-6$,-.$.4,/-$1,?$)I$1B0$
heat source.
6. Disconnect the electrical connections:
–
Disconnect 2 white connectors (1) at the
bottom of the electrical control cabinet. To
do this, release the lugs by pressing on the
sides of the connectors.
–
8:**$ ):1$ 1B0$ (*,35$ 4031,-6:*,4$ 3)--031)4$ R7X$
at the top of the module box.
