15
Subject to change without notice | 83057100hUK – Translation into English of the original German operating manual | ait-deutschland GmbH
3. Feed the control/sensor cables and unit supply
cable into the housing from the rear.
4. Route cables from underneath through the cable
openings in the control box.
5. Connect cables to the respective terminals
(
!
“Terminal diagram” on page 36).
Control the controller via a PC
1.
$a:4/-6$ /-+1,**,1/)-$ *,&$ ,$ +B/0*.0.$ -01G)45$ 3,(*0$
(category 6) through the unit.
2.
$8*:6$ 1B0$ <iT;=$ 3)--031)4$ )I$ 1B0$ -01G)45$ 3,(*0$
/-1)$1B0$+)3501$)I$1B0$3)-14)*$:-/1$R!X"
1
NOTE
QB0$ -01G)45$ 3,(*0$ 3,-$ (0$ 4014)2110.$ ,1$ ,-&$
time.
6.5 Installing the control
NOTE
The control can be inserted in a recess in the
front panel of the unit or can be installed on
the wall.
Insert the control in the unit and connect
1.
SI$ 409:/40.U$ <0')D0$ ',+5/-6$ ?*,10$ I4)'$ 1B0$
slot. To do this, dismantle the front panel
(
!
“Dismantle housing panels for transport with
handcart or carrying the unit” on page 9),
press the lugs together and push out of the
openings.
2.
<0')D0$2*'$I4)'$1B0$?*,+1/3$0*0'0-1$)I$1B0$I4)-1$
panel.
3. Position the control in the recess in the front unit
panel.
4. Cut the cable to length generously so that the
front panel can be removed and placed to the
side of the unit. Do not cut the cable ties for
strain relief of the LIN bus cable at the electric
control box.
–
PS[$(:+$3,(*0$,??4)\"$!"!$'$I4)'$1B0$2\/-6$)I$
the strain relief at the electrical control box
–
All other cables approx. 1.2 m
5. Use cable ties (
!
$ +0?,4,10$ ?,35X$ 1)$ 2\$ 1B0$ PS[$
(:+$3,(*0$1)$,$G0($)I$1B0$',+5/-6$?*,10$,4):-.$
20 cm in front of the connector (strain relief).
200 mm
6. Push the cable through the opening in the front
panel of the unit from below and into the control.
7.
Press the lugs of the control into the openings in
the front panel of the unit.
