9
Subject to change without notice | 83059100fUK – Translation of the original operating manual | ait-deutschland GmbH
●
The façade front is located in front of the device
●
The single-part and two-part side wall are located
on the rear side
Optional disconnection of the fan module
NOTE
The fan module can be removed if required
(narrow passages ) .
1. Disconnect the plug-in connection of the load and
bus cable at the top left on the refrigerant circuit
switch box.
2. Remove the 4 screws.
3. Remove the fan module and set it down safely.
4.
Break off the projecting struts on the supporting
crosspieces.
1 Lashing straps with grip openings
2 Styrofoam struts
3 Screws on the fan module
Disconnecting the evaporator module
NOTE
The evaporator module can be disconnected
from the refrigerant circuit module if required.
This work must be carried out by the factory
customer service department!
►
Please contact our factory customer service
department!
Carrying the unit and transporting with a
handcart
Housing walls are set down.
There are two lashing straps around the heat pump
module with grip openings at different heights. These
can be used for lifting and carrying.
To provide additional stability, two supporting cross-
pieces are clamped in the side cut-outs for the air
ducts. Do not remove these until transport is complete!
Transporting the heat pump module with a
handcart
1. Only place the heat pump module onto the
handcart with the narrow side, left or right.
2. Secure the heat pump module to the handcart
with lashing straps.
3. Transport the heat pump module to the installation
site.
