14
Subject to change without notice | 83059000dUK – Translation of the original operating manual | ait-deutschland GmbH
7 Installation of air ducting
7.1 Air outlet to right or left
Left air discharge:
Right air discharge:
Air duct installation instructions
Wall duct installation instructions
8 Attach side walls, rear wall
and cover
Heat pump installation instructions
1. Fasten rear wall.
2. Hang side walls from above. Fasten at the front
with a screw in the middle. Fasten with 2 screws
at the bottom.
3. Fit cover and screw into place.
9 Hydraulic installation
NOTE
If an existing system is being replaced, the
old vibration decouplers cannot be reused.
NOTE
Before connection to the heating system, the
heating circuit must be thoroughly flushed.
ATTENTION
Damage to the copper pipes due to unacceptable
loading!
►
Secure all connections against twisting.
Cross-sections and lengths of the pipes for the
heating circuit are adequately dimensioned.
The free pressing of the circulation pump produces
at least the minimum throughput required for the
unit type (
“Technical data/Scope of supply” on
page 23).
The cables for the heating are fixed to the wall or
ceiling via a fixed point.
Establish the hydraulic connection between
the heat pump module and the compact
module.
Establish the hydraulic connection between the heat
pump module and the compact module with the pre-
finished connection kit.
The rear wall must be installed for this!
Heat pump installation instructions
Connect the unit to the heating circuit
Install the compression fittings and ball
valves
ATTENTION
Leaks or fracture of the union nut due to excessive
force!
