11
Subject to change without notice | 83059000dUK – Translation of the original operating manual | ait-deutschland GmbH
4.
Break off the projecting struts on the supporting
crosspieces.
1
3
3
3
3
2
1 Lashing straps with grip openings
2 Styrofoam strut
3 Screws on the fan module
Disconnecting the evaporator module
NOTE
If required, the evaporator module can be
disconnected from the refrigerant circuit
module. This work must be carried out by the
factory customer service department!
►
Please contact our factory customer service
department!
Carrying the unit and transporting with
handcart
Housing walls are set down.
There are two lashing straps around the heat pump
module with grip openings at different heights. These
can be used for lifting and carrying.
To provide additional stability, two supporting
crosspieces are clamped in the side cut-outs for
the air ducts. Do not remove these until transport
is complete!
► Lift the heat pump module off the compact module
and set it down.
Carrying the compact module
►
Carry the compact module to the installation site
using the 4 lashing straps.
Use two carrying loops on each side
►
The compact module can also be carried on end,
with the switch box at the top.
Transporting the compact module with a
handcart
1. Load the compact module with the underside of
the unit on the handcart.
2. Secure the compact module to the handcart with
lashing straps.
3. Transport the compact module to the installation
site.
Transporting the heat pump module with a
handcart
1. Load the heat pump module only with the narrow
side, left or right, on the handcart.
