6.2 Introduction
6.2.1. Introduction to the display interface
6.2.2. Introduction to programming interface
NOTE:
The above is just a part of the display interface. The display mode of other
interfaces is similar to the above figure. You can determine the display meaning
according to the information displayed on the interface.
NOTE:
The above list is the key sequence interface when the ADL3000 is equipped
with all functions. If there is no customized function, there is no relevant display
interface. The displayed values are all primary data. Please Make sure that the set
ratio is consistent with the actual ratio.
METER INSTRUCTION
METER INSTRUCTION
22
23
1.Press “SET” and the screen shows “PASS”
2.Press “ENT” and the screen shows “0000”
3.Input “0001” as the password and press “ENT”
4.Set the parameters
5.After settings, press “SET” and the screen shows “SAVE”
6.Select “YES” and press “ENT” to save the settings
Examples of display interface:
Table 4 Partial display interface diagram
Current forward active energy
12.34kWh
Current total power 1.234kW
Current reversing active energy
12.34kWh
Current positive active power
demand 1.234kW
Phase A voltage 123.4V
Phase A current 12.34A
6.3 Meter setting
Figure 6-2 Flow chart of meter setting
Main interface
SET
Enter
Enter
Enter
Enter
Enter
Enter
Enter
SET
SET
SET
SET
SET
SET
SET
PASS
0001
BUS
Addr
SYS
Yes
No
SAVE
Discard data
Discard data
Enter the serial
number of
themeter
