8
ALMECO nv
Air and water technologies
Royennestraat 51, B-7700 Moeskroen
[email protected] - www.almeco.eu
8. WARRANTY INFORMATION
Subject to the restrictions mentioned below, your equipment warranty covers the repair or replacement, free of charge,
of parts acknowledged to be faulty by Almeco, as well as the labour necessary to repair the equipment for twelve months
from the date of shipment.
Please note that
• The warranty is dependent upon the manufacturers recommended maintenance and servicing being carried out at the
time intervals specified in this manual. It may be necessary to provide proof of this (maintenance records, invoices, etc).
• The motor within the Cleaning Station unit has a working life of 1000/1500 hours and the brushes may need replacing
after this period. This is considered to be normal wear associated with the use of the motor and therefore not covered
under the warranty. Spares can be purchased from Almeco.
• Work carried out under the warranty does not extend the warranty. In particular, the replacement of a part during work
carried out under warranty does not extend the lifespan of the part. The warranty which covers the replacement part
expires on the date of expiry of your equipment’s warranty.
• Parts replaced under the warranty become the property of Almeco.
• At no time will Almeco be liable for any of the costs to the buyer for labour, transportation or down-time resulting from
defective equipment furnished by Almeco.
What the warranty does not cover
• Maintenance and servicing operations necessary for the correct operation of the equipment, mentioned in the
maintenance sections of this document.
• If the defect was due to accident or misuse, operation in an application not approved by Almeco or unauthorised
modification or repair.
• Consumable parts and their routine replacement, such as filters etc.
• The replacement of parts that are subject to normal wear associated with use of the equipment, if this replacement is not
the consequence of a fault.
• Damage caused by natural phenomena, hail, flooding, storms or other atmospheric hazards, as well as damage caused by
accidents, fire or theft.
Our products are manufactured in compliance with applicable international standards and regulations. If you have any
queries regarding the use of our products, or if you are planning a special application, please contact Almeco.
9. REGULATIONS
The JetBlack Safety Cleaning Station is designed in accordance with the following directives:
Conforms to OSHA Standard 29 CFR 1910.242 (b)
EN 55014-1
EMC Directive (Emissions)
EN 55014-2
EMC Directive (Immunity)
EN 60335-2-69
Low Voltage (Electrical Safety Testing)
EN 61000-3-2
EMC - Limits for harmonic current emissions
EN 61000-3-3
Limits of voltage changes, fluctuations and flicker in public low-
voltage supply system
10. WEEE RECYCLING & MATERIALS DISPOSAL
Products bearing the below WEEE symbol should not be disposed of in general waste. These should be
taken to local facilities where they can be recycled free of charge. This will ensure minimum impact on
the environment and human health which could otherwise arise from inappropriate waste handling.
This product has been designed with environmental disposal in mind, all materials chosen are fit for
purpose, robust, yet easy to recycle. The back plate is painted mild steel, the main body is moulded ABS,
the air gun is a polycarbonate/ABS mix & all wiring is PVC insulated copper.
JETBLACK SAFET Y PERSONNEL CLEANING STATION
