ITA
ENG
FRA
ESP
DEU
POR
6-1624028 rev.6 05/07/2013
7 / 22
ENG
•
This manual is for qualified installers only and not for the final user. It is the
installer’s job to explain to the user how the automasm works, about
hazards related to it and the necessity for periodical maintenance.
•
The installaon must be carried out by qualified personnel only, observing
current standards concerning automac closing systems. More specifically,
installaon conformity calls for the observance of direcve 89/392 and
standards EN 12453 and EN 12445.
•
Make absolutely certain that the power is disconnected before carrying out
any work on the device.
•
The power lead must only be connected to supply lines fied with adequate
electrical protecon; a circuit breaker must also be installed to guarantee the
disconnecon of all the phases from the mains with a distance of at least 3.5
mm between the contacts.
•
Be parcularly careful when evaluang the safety devices to install and their
locaon. Always install an emergency stop device that will cut the power off in
case of necessity.
•
Use original components only. Allmac is not liable for damages if any other
components are used.
•
Do not work on the device if your hands or feet are damp or wet and do not
leave it exposed to the weather.
•
This device must be used only for the purpose it has been expressly designed;
any other use is considered improper and therefore dangerous.
•
Only qualified technicians must be allowed to service the unit, including
changing the courtesy light bulb whenever this is needed.
•
Make sure that the gate structure is solid, well balanced, and suitable to be
motorised. Also ensure there are no points of fricon when the gate is
moving.
Aenon!
