Allied Skid-Pac 1000, Безопасность, эксплуатация, техническое обслуживание и запасные части, Страница: 25 / 44

Allied Construction Products, LLC www.alliedcp.com
TM103349_SP1000B_15sep 15
9.0 Care & Maintenance - [cont’d]
9.5.6 How To Drain Oil – (1000)
1. Position the Skid-Pac on flat level surface with
easy access to both the oil fill and oil level plugs.
Refer to Figure 9-2.
2. Prevent contamination by cleaning area around
the oil level plug before removal.
3. Loosen, but do not remove the oil level plug.
4. Point the oil level plug downward so that oil will
drain.
5. Place a suitable container under the plug to catch
oil.
6. Remove oil level plug and drain oil.
IMPORTANT
Properly dispose of used oil. Obey all local
regulations for the disposal of these fluids.
IMPORTANT
If the oil is contaminated with water or dirt, flush the
eccentric housing with clean oil prior to oil
replacement.
7. Fill with new oil to proper level. Use correct type.
9.6 How To Check Condition of Bearings
Due to the high loads and rotational speeds, bearing
failure is usually sudden. A rattling or scraping sound
is a tell-tale sign of imminent failure. Visual inspection
of bearing requires removal of the bearing housing.
9.6.1 Bearing Replacement
IMPORTANT
When repairs are made, use only the manufacturer's
genuine parts. Substitute parts may not meet the
required standards for fit and quality, or may impair
function, safety and performance.
IMPORTANT
Bearings are interference press fit into housing.
Replacement requires a workshop equipped with a
manual arbor or hydraulic press.
Use standard mechanic’s techniques and tools to
disassemble and assemble the Skid-Pac.
Questions regarding maintenance, repair or operation
can be directed to Allied Technical Service. For
questions regarding replacement parts, contact
Allied’s Customer Service.
9.6.2 Bearing Removal
1. Remove hydraulic motor.
2. Remove the motor side bearing housing from the
eccentric housing.
3. Remove the eccentric mass.
4. Remove the other bearing housing.
5. Ensure the bearing housing is properly supported
and press only against the bearing’s inner race.
CAUTION
Crush injury. Eccentric mass is heavy.
Handle carefully to avoid injury to hands
or fingers.
IMPORTANT
Do not pry out the outer bearing race if it remains in
the housing. Place a small weld bead, @1/8 inch (3
mm) along the inside diameter. When cool, remove
the outer race.
IMPORTANT
Obey all local regulations for the proper disposal of
all used fluids.
9.6.3 Bearing Installation
IMPORTANT
Handle new bearings with care to prevent damage.
Do not remove from packaging until ready to install.
CAUTION
Bearings are interference press fit. Apply contact
pressure to the outer race only. Do not hammer on
the bearing rings.
1. Clean the bearing housing.
2. Lightly lubricate outer race of bearing.
3. Slowly press bearing into housing.
4. Clean and lubricate the eccentric shaft.
5. Slip bearing/housing onto shaft.
NOTE : Close
tolerance slip fit.