Allied HO-PAC 4000, Инструкция по безопасности, эксплуатации, техническому обслуживанию и запасным частям.

Страница: 25 / 44

Allied Construction Products, LLC www.alliedcp.com
15
TM574173_HP4000_18feb
9.0 Care & Maintenance - [cont’d]
9.5.2 Bearing Lubrication Type and Capacity
Bearing Lubrication – Type ISO VG32
The Allied Ho-Pac is factory filled with premium
quality hydraulic oil ISO VG32 combining non-foam
and anti-wear additives. The use of other oils shall
be permitted only if they have a minimum viscosity of
at least 12 cSt at an operating temperature of 66
q
C
(150
q
F).
Oil Capacity – 3.5 qt.
Approximate oil capacity is 3.5 qt (3.3 l).
Do not overfill. Excess oil (from over-filling) will
discharge through the pressure relief plug.
Oil Change Interval – 1000 Hours
Replace the bearing oil every 1000 operating hours,
or once per year. *Maintenance intervals are subject
to adjustment if operating under extreme operating
conditions.
9.5.3 How To Check Oil Level
CAUTION
Hot surface - Burn injury if contacted.
Some components of the machinery
become hot during operation. Allow parts
and fluids to cool before handling.
IMPORTANT
Contamination can shorten bearing life. Prevent dirt
and debris from contaminating the oil. Always clean
the area around the plugs prior to removal.
Oil Fill
Oil Level
Fig. 9-1 Oil Fill and Level Labels Identified
Fig. 9-2 Bearing Oil Fill & Level Plugs Identified
1. Position the Ho-Pac upright on a level surface
with easy access to both the oil fill and oil level
plugs.
2. Clean area around the oil level plug and remove.
3. The oil level should be visible at the lip of the
opening.
1 Bearing Housing
2 Plug
3 Label
4 Oil Level
Fig. 9-3 Oil Level for Bearings
9.5.4 How To Add Oil
1. Position the Ho-Pac upright on a level surface
with easy access to the oil fill and level plugs.
2. Clean the area around the oil fill plug and
remove.
3. Add oil until slight trickle from the opening.
4. Re-install and tighten oil fill and level plugs.
5. Wipe up any oil spills
Level
3
2
4