Allied Telesis x330-10GTX, Руководство по установке

Страница: 73 / 98

x330-10GTX Gigabit Ethernet Switch Installation Guide
73
Starting a Local Management Session
The switch supports the following types of management:
 Local management: Local management is performed through the
Console port on the management panel of the switch, and with the
management cable included with the product. The switch does not
require an IP address for local management.
 Remote network: You can also manage the switch over your
network from your workstations. For this, the switch requires a IPv4
or IPv6 address. The switch can obtain its address automatically
from a DCHP server on your network because it has both DHCPv4
and DHCPv6 clients. The default setting for the clients is enabled.
If the switch does not receive a response to its queries for an IP
address, it uses the default IPv4 address 169.254.42.42/16.
Local management sessions of the switch require a management cable.
There are two available cables from Allied Telesis. One cable comes with
the switch. It has an RJ-45 (8P8C) connector that connects to the Console
port on the switch and a DB-9 (D-sub 9-pin) connector that connects to
your workstation. Refer to Figure 37.
Figure 37. Management Cable Included with Switch
For workstations without a DB-9 connector, such as laptop computers,
Allied Telesis offers the VT-Kit3 management cable. The cable has a USB-
A male connector that connects to a USB port on your workstation. Refer
to Figure 38.
Figure 38. VT-Kit3 Management Cable