Allied Telesis AT-DC2552XS, Руководство по установке, Страница: 84 / 96

Chapter 7: Managing the Switch
84
Remote Network Management
You can manage the AT-DC2552XS / L3 switch remotely through any of
the Ethernet ports (1 through 64) or through or the NET MGMT (ETH0)
Ethernet port on the front panel of the switch. See Figure 1 on page 19 for
the location of these ports.
A management session may be established through these ports over an
Ethernet network. The requirements for remote management of the switch
are listed here:

A terminal or computer with a VT100 or equivalent terminal
emulator program with a connection to your Ethernet network.

A connection from the AT-DC2552XS / L3 Enterprise Core Switch
to your Ethernet network.

You can also manage the switch using the NET MGMT (ETH0)
port which is an Ethernet port, but is out of band from normal
Ethernet traffic. Refer to the “NET MGMT Cable Installation,” next
on this page to connect to this port.
With remote management, you can choose to use the CLI or SNMP. The
CLI gives you access to all of the features and parameters of the switch.
If you want to use SNMP, you must initially start with the CLI SNMP
configuration commands where you can customize the SNMP interface.
Refer to the AT-DC2552XS / L3 Management Software Command Line
Interface User’s Guide for more information at alliedtelesis.com/support/
documentation .
NET MGMT
Cable Installation
The NET MGMT port is a 10/100/1000BASE-T, RJ-45 port located on the
front panel of the switch. See Figure 1 on page 19 for this port’s location.
Perform the following procedure to install the cable in the NET MGMT
port.
1. Select a twisted pair cable from Table 1 on page 21 to connect to the
NET MGMT port.
2. Place the locking tab on the bottom and insert the twisted-pair cable
into the NET MGMT port. See Figure 44 on page 85. The connector
should click into place when it is fully seated.