32
SHOW IP IGMP DEBUG
Patch Release Note
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
SHOW IP IGMP DEBUG
Syntax
SHOW IP IGMP DEBUG
Description
This command shows the IGMP debugging options that have been set.
Figure 4: Example output from SHOW IP IGMP DEBUG.
Examples
To display IGMP debugging information, use the command:
SHOW IP IGMP DEBUG
See Also
DISABLE IP IGMP DEBUG
ENABLE IP IGMP DEBUG
Checking the Port Map on Rapier16f
i
Switches
This section explains how to check that the port map on your Rapier16f
i
is
correct. If the port map on your Rapier16f
i
is incorrect, this Note explains how
to restore the correct settings.
This information is for Rapier16fi switches only.
The port map on your Rapier16f
i
will be incorrect if:
■
it has software release 86s-251, but the 86251-04 patch is
not
loaded, or
IGMP Debugging Information
--------------------------------------------------------------------------------
IGMP Debugging Enabled
Filter by group destination 224.1.2.3
Filter by source IP 10.10.1.123
--------------------------------------------------------------------------------
Table 7: Parameters displayed in the output of the SHOW IP IGMP DEBUG
command.
Parameter
Meaning
IGMP Debugging
Whether or not IGMP debugging is enabled; one of
"Enabled" or "Disabled".
Filter by group destination
The Group Destination Address specified by the
DESTINATION parameter in the ENABLE IP IGMP DEBUG
command. If the parameter was not given, "No" is
displayed instead of the IP address.
Filter by source IP
The source IP address specified by the SOURCEIPADDRESS
parameter in the ENABLE IP IGMP DEBUG command. If the
parameter was not given, "No" is displayed instead of the
IP address.
