Patch 86251-05 For Rapier Switches and AR800 Series Modular Switching RoutersENABLE IP IGMP DEBUG
31
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
DISABLE IP IGMP DEBUG
Syntax
DISABLE IP IGMP DEBUG
Description
This command disables all IGMP debugging messages and resets the
DESTINATION and SOURCEIPADDRESS parameters set in the ENABLE IP
IGMP DEBUG command to ALL. Debugging is disabled by default.
Examples
To disable all IGMP debugging messages and reset the IGMP debug message
filters to ALL, use the command:
DISABLE IP IGMP DEBUG
See Also
SHOW IP IGMP DEBUG
ENABLE IP IGMP DEBUG
Syntax
ENABLE IP IGMP DEBUG [DESTINATION={ALL|
ipaddress
}]
[SOURCEIPADDRESS={ALL|
ipaddress2
}]
where:
■
ipaddress
is an IGMP group destination address.
■
ipaddress2
is the IP address of a host that responds to IGMP queries.
Description
This command enables IGMP debugging of destination and source IP
addresses. Debugging is disabled by default.
The DESTINATION parameter specifies the destination multicast group
address for debugging. The default is ALL.
The SOURCEIPADDRESS specifies the host IP address responding to IGMP
queries. The default is ALL.
If DESTINATION and SOURCEIPADDRESS are both specified, only debug
messages that match both parameters are displayed. Some debug messages are
displayed before the packet is fully decoded, and are unable to be filtered.
Examples
To enable debugging information relating to IGMP host 10.41.0.22, use the
command:
ENABLE IP IGMP DEBUG SOURCEIPADDRESS=10.41.0.22
To show all IGMP debug messages, use the command:
ENABLE IP IGMP DEBUG
See Also
SHOW IP IGMP DEBUG