28
ADD IP IGMP DESTINATION
Patch Release Note
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
New Commands
ADD IP IGMP DESTINATION
Syntax
ADD IP IGMP DESTINATION=
ipaddress
INTERFACE=
interface
PORT={ALL|
port-list
}
where:
■
ipaddress
is an existing IGMP group destination address.
■
interface
is the name of the interface over which multicast data is
forwarded. This must be a VLAN interface.
■
port-list
is a port number, a range of port numbers (specified as a-b), or a
comma separated list of port numbers and/or ranges. Port numbers start
at 1 and end at m, where m is the highest numbered Ethernet port,
including uplink ports.
Description
This command adds additional ports, through which multicast data is
forwarded.
The DESTINATION parameter specifies the IP address from where multicast
data is forwarded.
The INTERFACE parameter specifies the interface over which multicast data is
forwarded. This must be a VLAN interface, e.g. VLAN1.
The static IGMP association identified by the DESTINATION and INTERFACE
parameters must already exist.
The PORT parameter specifies the ports through which multicast data is
forwarded. If any of the ports specified in the port list are already part of the
association, or are not valid ports for the specified interface, an error message is
displayed.
A port may belong to several associations if it belongs to several interfaces (i.e.
if there are overlapping VLANs). If one of the ports specified in the port list
already has a dynamic IGMP host, it will be replaced by the new static entry. If
ALL is specified, all ports belonging to that interface will forward multicast
data.
Examples
To add port 5 to the list of ports through which multicast data for 224.1.2.3 will
be forwarded over
vlan1
, use the command:
ADD IP IGMP DESTINATION=224.1.2.3 INTERFACE=VLAN1 PORT=5
See Also
DELETE IP IGMP DESTINATION
SHOW IP IGMP
