Patch 86251-05 For Rapier Switches and AR800 Series Modular Switching Routers
23
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
When ports were added to a trunk group on a Rapier 16, the ports operated
in the wrong duplex mode. This issue has been resolved.
Layer 3 filtering was not correctly modifying a packet's IPDSCP field. This
issue has been resolved.
The ADD FIREWALL POLICY RULE command included an erroneous
check on port ranges for non-NAT rules. This check is now restricted to
NAT rules.
If the ENABLE IP IGMP command was executed before the ENABLE
SWITCH L3FILTER command, Layer 3 filtering did not discard packets
destined for the CPU. This issue has been resolved.
Sometimes IP flows were not deleted correctly when both directions of the
flow were in use. This issue has been resolved.
The ECPAC card was not working correctly. This issue has been resolved.
Features in 86251-01
Patch file details are listed in Table 5:
Patch 86251-01 includes the following enhancements:
IP is now informed when an Ethernet interface goes up or down, after a 2.5
second delay.
The ADD IPV6 HOST command was not accepting the INTERFACE
parameter when adding a host with a link-local address. This issue has been
resolved.
PCR: 03015
Module: SWI
Network affecting: No
PCR: 03029
Module: SWI
Network affecting: No
PCR: 03031
Module: FIREWALL
Network affecting: No
PCR: 03032
Module: SWI
Network affecting: No
PCR: 03040
Module: IPG
Network affecting: No
PCR: 03051
Module: PCI
Network affecting: No
Table 5: Patch file details for Patch 86251-01.
Base Software Release File
86s-251.rez
Patch Release Date
23-December-2002
Compressed Patch File Name
86251-01.paz
Compressed Patch File Size
11884 bytes
PCR: 02331
Module: IPG, ETH
Network affecting: No
PCR: 02525
Module: TELNET, PING, IPV6,
TCP
Network affecting: No
