Chapter 5: Configuring the CopperJet
Page
16
Select DHCP Server en click on Configure. The DHCP Subnet page is displayed.
This page allows you to:
•
Set the subnet for the DHCP Server manually OR use the same subnet
used on the IP interface by selecting Use Subnet of IP interface.
•
Set the DHCP address range manually OR use a default range of 253
addresses by selecting Use Default Range.
•
Set the default and maximum lease times for this DHCP Server.
•
Set your CopperJet to give out its own IP address as the DNS Server
address OR manually set the primary and secondary DNS Server
addresses. When Use Router as DNS Server is selected, DNS Relay will be
enabled.
•
Set your CopperJet to give out its own IP address as the default Gateway
address. In most situations this is enabled.
Once you have entered new configuration details for your DHCP server, click on
OK.
On the next screen, at the bottom, click on the Configure the DHCP server button
to activate the DHCP server.
