ALLIANCE SWT421, Руководство по программированию

Страница: 66 / 75

64
36198
Diagnostic Test Descriptions
Diagnostic Test
This option is used to test various LED lights, water
temperatures, signals, motor directions and relays.
This test is activated by pressing and holding the
COLD keypad with one hand, then pressing the
NORMAL keypad with the other hand.
The Diagnostic Test Routine defines each step of the
test. See Chart 9. Each step will last for five seconds.
When the last step in the table is finished, the
diagnostic routine will restart at the top of the table.
To exit the Diagnostic routine, either press any keypad
or open the washer lid. The control will return to the
“Ready” mode. See Figure 2. If this exit procedure is
not done, the control will start again and go through
the test routine until stopped.
Chart 9: Diagnostic Test Routine
Time
Display
Illuminated
LED’s/VFD
Motor
Direction
Motor Relay
Hot
Water
Cold
Water
Signal
005 All ON High Agitate K4 OFF OFF OFF
110 All OFF High Agitate K4 ON ON OFF
115 All ON High Agitate K4 OFF OFF OFF
220 All OFF None OFF ON ON OFF
225 All ON None OFF OFF OFF OFF
330 All OFF None OFF ON ON OFF
335 All ON Low Agitate K4, K5 OFF OFF OFF
440 All OFF Low Agitate K4, K5 ON ON OFF
445 All ON Low Agitate K4, K5 OFF OFF OFF
550 All OFF None OFF ON ON OFF
555 All ON None OFF OFF OFF OFF
650 All OFF None OFF ON ON OFF
665 All ON High Spin K3, K4, K6 OFF OFF OFF
770 All OFF High Spin K3, K4, K6 ON ON OFF
775 All ON High Spin K3, K4, K6 OFF OFF OFF
880 All OFF None OFF ON ON OFF
885 All ON None OFF OFF OFF OFF
990 All OFF None OFF ON ON OFF
995 All ON Low Spin K3, K5, K4, K6 OFF OFF Lowest
999 All OFF Low Spin K3, K5, K4, K6 ON ON Medium
888 All ON Low Spin K3, K5, K4, K6 ON ON Highest
000 All OFF None OFF OFF OFF OFF