ALLIANCE SWT421, Руководство по программированию

Страница: 46 / 75

44
36198
20. Coin Value “COI”
This option allows the user to set a specific numerical
value for a coin entered. For example, in the United
States the coin value for one quarter would be
measured in cents (25). Therefore, the coin value
entered for one quarter would be 025.
If the Hot Wash Number of Coins (option 2) is set for
3 coins, and the Coin Value is set for “025,” the vend
price for a Hot Wash will be “.75.”
How to Program Coin Value
1. Control must be in Special Mode. Refer to Section
VII.
2. While pressing and holding the PERM PRESS
keypad with one hand, press the COLD keypad
with the other hand. Programmable option number
one,
“SIg”
, will appear in the VFD. See Figure 61.
3. Press the DELICATES (+) pad or the COLD (-)
pad to scroll through the programmable options
until
“COI”
appears in the VFD. See Figure 62.
4. When
“COI”
appears in the VFD, press the PERM
PRESS pad twice. The current coin value will
appear in the VFD.
IMPORTANT: The PERM PRESS pad must be
pressed TWICE before the coin value will be
displayed.
5. Press the DELICATES (+) or the COLD (-) keypad
to increase or decrease the current three digit
number to the desired three digit number. See
Figure 63.
IMPORTANT: Do not scroll to a value greater than
255 as the control will not allow going below 256. If
the user scrolls to a value higher than 255, turn off
the power BEFORE pressing PERM PRESS
(enter). This will return the control to the “Ready”
mode with the original coin value programmed. If
PERM PRESS (enter) is pressed with a value
greater than 255, a Micro-Wand must then be used
to return to a value less than 256.
6. Press the PERM PRESS (enter) keypad when the
correct coin value appears in the VFD. The next
option,
“dCS” , will appear in the VFD.
NOTE: To program
“dCS”
(Default Cycle Select),
see option 21. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
1. Be sure service door has been opened and closed.
Refer to Section VI.
2. Be sure the control shows a programmable option,
not a value.
3. While pressing and holding the PERM PRESS
keypad with one hand; press the COLD keypad
with the other hand. The control will revert back to
the “Ready” mode. See Figure 2.
Figure 61
Figure 62
WASH RINSE SOAK
SPIN
PRICE TIME REMAINING
INSERT COINS UNBALANCE
C105IE1A
WASH RINSE SOAK
SPIN
PRICE TIME REMAINING
INSERT COINS UNBALANCE
C125IE1A
Figure 63
NORMAL
HOT
DELICATES
COLD
PERM
PRESS
WARM
Press this pad (enter)
to choose a selected
value or option
Press this pad (+)
to scroll forward or
increase a value
Press this pad (-)
to scroll back or
decrease a value
C106IE1A