ALLIANCE SWT421, Руководство по программированию

Страница: 19 / 75

36198
17
Section VII
Entering the Special Mode
For programming, testing, and retrieving information
from the Electronic Control, it is often necessary to
enter the Special Mode by following the four simple
steps below.
How to Enter the Special Mode
1. Be sure the washer is in the “Ready” mode before
continuing to step 2. See Figure 2. If the washer is
in an active cycle, rapid advance through the cycle.
See the Rapid Advance feature (Section XII). If
coins have been entered, see the Clear Vend feature
(Section XIII).
2. Open the service door located on the top of the
meter case. See Figure 3.
3. While pressing and holding the NORMAL keypad
with one hand, press the HOT keypad with the
other hand.
4. The VFD display will show SPC.” See Figure 4.
The rest of this section describes the six special
features that the control can enter. It is necessary to
enter the Special Mode when programming special
features 1 - 4 in the list below.
1. Programming the Electronic Control
2. Collecting Audit Information
3. Testing Machine and Electronic Control Functions
4. Sales Floor Feature
5. Rapid Advance Feature
6. Clear Vend Feature
Once in the Special Mode, continue on into one of the
features described in detail on the following pages.
Instructions on how to exit each feature are found at
the end of each feature description.
Figure 4
NORMAL
HOT
DELICATES
COLD
FABRICS AND TEMPERATURES
PERM
PRESS
WARM
C104IE1A
WASH RINSE SOAK
SPIN
PRICE TIME REMAINING
INSERT COINS UNBALANCE