ALLIANCE SWNNC2HP115TQ01, Оригинальное руководство пользователя

Страница: 85 / 90

Error Codes
Display Description Cause/Corrective Action
E nFLo
No Water Flow Er-
ror If the control does not reach a water level of 0.5 inches within the programmed time it
may mean the hose to the pressure sensor has a leak or no water is flowing into the
machine. The control will enter Machine Error mode. The control will turn off all out-
puts and turn on the Machine Error Tone for 15 seconds. To clear this error one of the
following must occur: the machine must be powered down, the Clear Fatal Error Keys
must be pressed, or a Clear Fatal Error Network command must be sent.
E oF
Overflow Error The machine must be powered down, the Clear Fatal Error Keys must be pressed, or a
Clear Fatal Error Network command must be sent. This error is triggered when an un-
safe high water level is detected in the machine and water is unable to drain.
E PS
Pressure Sensor
Error If the control does not detect a valid water level sensor input for thirty (30) seconds, or
if the Max (Overflow) Fill Level in the control is set to 0 while in Run Mode, Factory
Test Mode, or Overflow Mode, the control will enter Machine Error Mode. To clear
this error one of the following must occur: the machine must be powered down, the
Clear Fatal Error Keys must be pressed, or a Clear Fatal Error Network command
must be sent.
E LF
Water Leak Fill
Error If the water level has raised more than an acceptable amount in a during a water leak
check, the control will save a water leak error status and will continue the machine
cycle. Immediately upon detecting the error the right-most decimal point will be lit.
This lit decimal point can be cleared by pressing the START keypad 3 times in a peri-
od of 5 seconds or by cycling the power to the machine.
Display is dim Look for loose pins and damaged wires on harness from user control to drive board.
E tP
Thermal Protect
Error This error occurs when the motor thermal protect opens. If a cycle is running, the au-
dio will sound for five seconds and the cycle will stop for two minutes. If the motor
thermal protect is closed and the lid was not opened during the duration of the error,
the cycle will resume automatically. If the lid was opened, the display will show
PUSH
,
StArt
,
E tP
indicating that the START keypad must be pressed to resume
the cycle.
E d
xx
Drive/Output
Board Error A machine error tone will sound for 15 seconds. Fatal error condition detected by
drive board where xx represents an error code. Power down machine to clear. Call a
service technician if error persists.
Error Codes
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
85 Part No. 204370ENR1