ALLIANCE ALLPH120R410-INV, Руководство по установке и эксплуатации

Страница: 26 / 27

11. ALLIANCE heat pumps MUST always be installed outdoors, with unrestricted air flow around the heat
pump.
12. The size and model of the ALLIANCE domestic swimming pool heat pump selected must be appropriate
to the specific application and sized using Alliance’s swimming pool sizing calculator.
13. Use of non-factory authorized parts or accessories in conjunction with this product will void this
Warranty.
14. Not maintaining a proper chemical balance in your pool (pH level between 7.0 and 7.8. Total Alkalinity
(TA) between 80 and 150ppm. Free Chlorine between 0.5 – 1.2mg/l. Total dissolved solids 9 (TDS) less
than 1200ppm. Salt maximum 8g/l) will void this Warranty.
15. Overheating, incorrect wire runs, improper electrical supply, collateral damage caused by failure of O-
Rings or damage cause by running the pump with insufficient water flow will void this Warranty.
16. For coastal and corrosive environment installations, Blue Chem or similar treatment against corrosion is
required for warranty claims to remain valid.
17. Parts and warranty details:
Controller, PC boards, Capacitor, Relays, Sensors – 2 Year warranty (Part only after 1 st year)
High pressure / low pressure switch – 2 Year warranty (Part only after 1 st year)
Water flow switch – 2 Year warranty (Part only after 1
st
year)
EEV / Solenoid – 2 Year warranty (Part only after 1
st
year)
Titanium heat exchanger – 5 Year warranty (Part only after 1
st
year)
Compressor – 5 Year warranty (Part only after 1 st year)
ALLIANCE reserves the right to update or modify this warranty (including terms and conditions) any time
without prior notice
Service Schedule:
 Clean evaporator coil (High Pressure Washer)
 Check outdoor fan motors
 Check fan blades for damage / out of balance

Check all electrical connections

Check for oil spots on refrigerant piping
 Check & clean condensate drains
 Check heating operation
 Check refrigerant standing and running pressures
 Check running current
 Measure on & off coil temperatures
 Clean unit cabinets
Service No Date Technician Name Technician Sign
1
2
3
4
5
6
7
8
9
10
By signing this service record the authorised Alliance dealer technician confirms that the service has
been carried out and that the unit is in a satisfactory working condition and performing to specification.
24