Alliance Laundry Systems BWNBC2PP112TW01, Программирование

Страница: 24 / 28

To Exit Production Test Cycle
The control must be powered down to end the test.
Production Test Cycle Quick Reference Table
Display Test Mode Comments
S---
Software Version
---
is the software version number.
PAd-
Keypad Test When a key is pressed, the control will display the number assigned to
the keypad (1 – NORMAL/HOT, 2 – NORMAL/WARM, 3 – PERM
PRESS/ WARM, 4 – DELICATES/COLD, 5 – START). As each key-
pad is pressed, its corresponding LED will be lit and remain on for the
duration of the test. When all keypads have been pressed, the control
will advance to Coin Drop Test step.
C-C-
Coin Drop Test
-
is the number of coins entered. If dual coin drops are installed, coin
drop #1 will be shown on the left of the display and coin drop #2 will
be shown on the right of the display. If a single coin drop is used, only
one coin count will be displayed and the other side will remain at zero.
S --
Service Door Switch Test
--
is the number of service door switch openings.
U --
Coin Vault Test
--
is the number of coin vault openings.
All LEDs and display
segments will light Show Entire Display Mode None
0001
Step #1 Test SPIN LED is lit and control energizes high speed spin motor outputs.
0002
Step #2 Test Motor outputs are off and hot water valve is on.
0003
Step #3 Test Motor outputs are off and cold water valve is on.
0004
Step #4 Test Motor outputs are off and hot and cold water valves are on. Control
will remain in this mode until machine fills and pressure switch opens.
All keypad presses are ignored until step is complete.
0005
Step #5 Test RINSE LED is lit and control energizes the high speed agitate motor
outputs.
0006
Step #6 Test RINSE LED is lit and control energizes low speed agitate motor out-
puts.
0007
Step #7 Test SPIN LED is lit and control energizes low speed spin motor outputs.
0008
Step #8 Test SPIN LED is lit and control energizes high speed spin motor outputs.
0009
Step #9 Test LEDs are off, motor outputs are off, and hot and cold water valves are
on.
0010
Step #10 Test SPIN LED is lit and control energizes high speed spin motor outputs.
Table 4
Testing Machine and MDC Functions
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
24 Part No. 202713ENR1