Allflex AWR300 User Guide
13/11/19
Page 36
If the baud rate of the scale differs from the configured scale baud rate on the AWR300, this
might cause communication issues when using Bluetooth as the scale interface. For an RS232
connection, the communication will not work if the baud rates do not match. They must be
configured to the same values on both devices.
Screen
Details
Select the correct baud rate using the / keys and
confirm with .
Baud rates from 300bps to 115200bps are possible in
particular steps.
6.5.3.3
Setup Printer
Screen
Details
The printer setup is the same as described in Chapter 6.5.5,
This is another menu entry for configuring the same
settings.
6.5.3.4
Bluetooth
The AWR300 incorporates a Class1 Bluetooth module. The range is up to 80 meters in ‘line of
sight’. When inside buildings or when any other obstacles are present, the range is lower. Note
that the range also depends on the Bluetooth partner. If the other device is only Class2, the
range is much lower. This applies particularly to devices like smart phones.
The Bluetooth menus and configuration are explained here.
Screen
Details
/ … One item down / up
/ … Switch to first / last item
… Enter submenu resp. start action (BT Inquiry)
6.5.3.4.1
Bluetooth Mode
The Bluetooth Mode determines if the AWR300 can initiate the connection to another device
(Master Mode) or if other devices can connect to the AWR300. By default, Bluetooth is not
activated (OFF), so it must be switched on first. Then you need to decide whether the AWR300
should be the device initiating the connection (Master) or the other device (Slave).
