Allen-Bradley SLC 500 DeviceNet, Руководство пользователя, Страница: 70 / 139

Publication 1747-6.5.5 - August 2000
5-2 Communicating with DeviceNet from Another Network
Where to Find
More Information
Refer to the following publications for information on configuring
other networks:
System Requirements To use the pass-through feature you must have the following versions
of the RSLinx software and 1747-SDN module firmware:
More
For information about: See this publication: Publication
number:
the Data Highway Plus network SLC Modular Style Hardware Installation and Operation Manual 1747-6.2
the Ethernet interface Ethernet SLC 500 Processors Quick Start for Experienced Users 1747-10.4
TCP/IP protocol and networking in general Comer, Douglas E.,
Internetworking with TCP-IP, Volume 1:
Protocols and Architecture , 2nd ed. Englewood Cliffs,
N.J.:Prentice-Hall, 1995. ISBN 0-13-216987-8.
n/a
Tannebaum, Andrew S.
Computer Networks
, 2nd ed. Englewood
Cliffs, N.J.: Prentice-Hall, 1989. ISBN 0-13-162959- X .
n/a
Component Software/Firmware Version
RSLinx software 2.10 or higher
1747-SDN module 4.015 or higher
IMPORTANT
To enable pass-through access with a SLC 500
processor, you must use RSLogix 500 to configure
the M0 and M1 files associated with the 1747-SDN
module with a minimum length of 361 words. You
can access the M file configuration by launching I/O
Configuration within RSLogix 500, and then selecting
the 1747-SDN. See Appendix E for details.
The SLC 500 processor must be placed in Run mode
at least once since its last power cycle for 1747-SDN
pass-through transactions to succeed.
IMPORTANT
You must have previously set up the network you
will use to communicate with the DeviceNet network
and have installed and configured the appropriate
drivers and interface hardware.