Allen-Bradley SLC 500 DeviceNet, Руководство пользователя, Страница: 109 / 139

1 Publication 1747-6.5.5 - August 2000
Appendix
C
Configuring the Processor’s RS-232 Port for
the ControlNet Interface
Before you can communicate with your SLC 500 processor over a
ControlNet network, you must configure channel 0 (the RS-232 serial
port) of the processor to match the serial port settings of the
1747-KFC15 ControlNet Interface Module.
•
If you are interfacing your SLC 5/04 processor to a DH+ network
you can do this configuration via the DH+ network. See chapter
6 for information on going online to the processor over a DH+
network.
•
With an SLC 5/05 processor you can do the ControlNet
configuration via an Ethernet network. See chapter 6 for
information on going online to the processor over an Ethernet
network.
•
You can also do the configuration using a DF1 driver connected
to the processor’s RS-232 serial port. See Appendix F for
information on accessing the processor via the DF1 driver.
Configuring the RS-232 Port
Using RSLogix 500 To configure the RS-232 serial port to interface with the 1747-KFC15
module perform the following steps:
1. Run RSLogix 500 and go online to the processor using one of the
methods outlined above.
2. In the Project window double-click on Channel Configuration
under the Controller folder.