57
8VHIXOIXQFWLRQV
6LQJOHEDQGPRGH
This is to use the unit as a single-band radio by eliminating the display on the opposite side.
1.
Press FUNC key and while [FUNC]
appears on the display, press VOL knob
of the desired side to operate. The
display of the opposite side will
disappear.
2.
Press the VOL knob of opposite side to
switch the band to operate.
Press FUNC then press a VOL knob to
resume a dual-band operation.
9)2$XWRSURJUDPIXQFWLRQ
This is a “customized AUTO repeater” feature. Parameters set in this feature has a priority over the
conventional AUTO-repeater setting, and can be activated both at the same time.
The parameters available for this functions are the upper/lower limit of the range, shift direction, offset width,
and CTCSS/DCS encode/decode setting. (P.65)
1.
In VFO mode, tune to the lower limit
frequency and set the offset direction/
width, tone status as preferred. Press
FUNC key and rotate the dial of the same
VFO you operated to select APL.
Press the V/M key of the same side to
save.
2.
Tune to the higher limit frequency, repeat
above 1 to select APH and set. APH setting
is valid only the frequency and other
parameters will be disregarded. APH
frequency should be higher than APL
otherwise doesn’t work. APL and APH can’t
accept temporary change of the
programmed data.
3.
Disable shift and tone settings operated in
above 1. Move to the AUTO-program range
and see if desired setting is automatically
applied.
When 439.000MHz 88.5Hz
ENC-5.000MHz shift is set in APL
APH is set to 439.980MHz
Shows an example within
VFO auto-program setting
Содержание DR-735T/E
Страница 82: ...80 MEMO...
Страница 83: ...81 MEMO...
