32
Basic Operations
5HYHUVH)XQFWLRQ
This function is to monitor the transmitting frequency
instead of receiving frequency in repeater operation.
This technique is commonly used to check if it is
possible to communicate without using repeater by
monitoring the accessing station’s signal strength.
1.
Set SHIFT
¿
rst. Press FUNC key then
press MW key while [FUNC] appears on
display.
[
] icon appears on the display to indicate that the
reverse function is activated and the squelch opens.
2.
Pressing any key on the front panel will
cancel the operation.
IMPORTANT
The Reverse function only operates on the MAIN band.
Without SHIFT setting Monitor function will operate instead of Reverse
function.
NOTE
Rotate squelch knob counterclockwise to monitor repeater’s down link.
In case tone squelch or DCS decoding is used, it is necessary to turn off
these functions to monitor.
7R7UDQVPLW
1.
Set the transmitting band to the MAIN
side.
2.
Check the system and monitor the
frequency to make sure that you are not
going to disturb any ongoing
communications.
3.
Press the PTT key on the microphone.
The TX lamp (red) illuminates to show the unit is
transmitting.
4.
Speak into the microphone in a normal
voice while keeping the PTT key pressed.
Hold the microphone approximately 5cm away from
your mouth. Speaking too close or too loud may result
in poor audio. Adjust microphone gain in set mode (Menu
03) when necessary.
Auto repeater setting
TX lamp
Содержание DR-735T/E
Страница 82: ...80 MEMO...
Страница 83: ...81 MEMO...
