54
Set mode menu
0HQX0LGRXWSXWSRZHU
This is to customize the Mid output power. The setting is assignable to VHF and UHF bands,
but not VFOs. Available levels are 21 and between 50 and 5 Watts. Default is zero, and
represents 20W.
Use of a power-meter and a dummy load is recommended for acurate adjustment.
1.
Press and hold FUNC key to enter the set
mode. Press dial to select menu 30.
2.
Rotate the left dial for VHF, right for UHF.
Negative icon represents lower output,
positive for higher output.-10 is lowest
(approx. 5 W), +10 is highest
(approx.50 W).
You can transmit while tuning; use VOL
knobs to switch MAIN band.
3.
Press any key other than PTT to set and
exit, or press the dial or UP/DOWN keys
to set and move to another menu.
IMPORTANT
This operation is possible only in the transmitting range and a waring beep sounds
otherwise.
0HQX,PDJHVLJQDOUHMHFWLRQ
This feature may eliminate interference caused by unwanted image signal being received
such as hearing FM braodcast in amateur radio bands.
NOTE
This function is not a noise blanker and may not be effective in all cases of
image signal interferences.
1.
Press and hold FUNC key to enter the set
mode. Press dial to select menu 31.
Factory default setting is [N].
2.
Rotate either left or right dial you wish to
apply change and select R (reverse).
This is selectable separately in VFOs, but not for each
band.
3.
Press any key other than PTT to set and
exit, or press the dial or UP/DOWN keys
to set and move to another menu.
Содержание DR-735T/E
Страница 82: ...80 MEMO...
Страница 83: ...81 MEMO...
