Alinco DR-735T/E, Инструкция по эксплуатации

Страница: 39 / 84

37
Set mode menu
3. Press any key except PTT to set and exit,
or press the dial or UP/DOWN keys to set
and move to another menu.
IMPORTANT Pressing PTT switch will not exit the set mode setting in this menu.
0HQX6FDQW\SHVHOHFWLRQ
This is to select the scan resume condition. The BUSY setting resumes scanning when
received signal is gone and the TIME setting allows the radio to resume scanning after 5, 10,
20,30 or 60 seconds. This parameter can be selected for both left and right VFO but cannot
be selected for each band.
1. Press and hold FUNC key to enter the set
mode. Press dial to select menu 04.
Factory default setting is [BUSY].
2. By rotating the dial, the display changes
as shown.
3. Select a desired parameter.
4. Repeat the same operation by selecting
another side of VFO if the same mode is
always desired whichever the VFO you
use.
BUSY TIME05 TIME10 TIME20 TIME30 TIME60
(seconds)
5. Press any key to set and exit, or press the
dial or UP/DOWN keys to set and move to
another menu.
0HQX0HPRU\VFDQPRGHVHOHFWLRQ
Use this function to select memory scan conditions. (P.59)
This parameter can be selected for both left and right VFO but cannot be selected for each
band.
1. Press and hold FUNC key to enter the set
mode. Press dial to select menu 05.
Factory default setting is [SKIP].
ALL SKIP FAV