29
SEND DTMF SIGNALING
MAIN/SUB BAND SWITCHING
FUNCTION OPERATION THROUGH PA-PD kEYS
You can operate the transceiver by keypad or input desired frequency
and channel through the EMS-77 microphone.
Hold the [PTT] key; input the desired DTMF signaling by the numeric
keys.
At the default setting, both MAIN and SUB bands are displayed. The
transmitting is possible only on the frequency/channel shown on the
LEFT.
To transmit, press the
[M/S]
key to set the desired frequency or channel
on the LEFT side of the display.
This function is valid only when current channel set with offset frequency.
PRI
:
Add or delete priority channel: In channel mode, press the key
programmed as PRI function to set priority channel, when the LCD
displays "P1"
,
the current channel is
set as priority channel. Repeat above
operation, the "P1"
icon
disappear, the
curent channel is not set as priority channel.
LOW
: Output power setup, in standby, press the key programmed as as
LOW function will change the power level. When LCD displays
HIGH, the transmitting power on current channel is high. When
LCD displays MID1, the transmitting power on current channel
is middle1, When LCD displays MID2, the transmitting power on
current channel is middle 2. When LCD
displays LOW, the transmitting power on
current channel is low.
TONE
: CTCSS/DCS code setup. In standby, press the key programmed
as TONE function will be able to setup CTCSS/DCS code. When
the LCD displays " " and CTCSS frequency, press the
[UP/
DOWN]
key to choose CTCSS encode. When the LCD displays
"
" and CTCSS frequency, press
the microphone
[UP/DOWN]
key to
choose CTCSS decode. When the
LCD displays "DCS" and DCS code, press the microphone
[UP/
DOWN]
key to choose DCS code.
MHZ
:
In VFO mode, press the key
programmed
as MHZ function, the megabit digital in
the LCD flashes, now rotate the dial or
microphone
[UP/DOWN]
key to adjust frequency by 1Mhz step.
This function must be preprogrammed using the utility software in
advance.
RPTR:
OFFSET direction setup, in standby,
press the key programmed as RPTR
function will change the offset direction. When LCD displays "+",
means plus offset, when the LCD displays "-", means minus offset.
NOTE
PTT
Main/Sub band switch
UP
DOWN
MIC
Numeric Keys
[UP/DOWN] lock key
Microphone speaker
Microphone Operation
7
