Replacing the rear bezel
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
Before working inside your computer
. After working inside your computer, follow the instructions
After working inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
Procedure
1
Route the rear I/O accessibility lighting cable through the slot on the chassis.
2 Align the tabs from inside the chassis on the right side and left side, securing the rear bezel to the chassis and snap it in
place.
3 Replace the screw (M3x5) from inside, that secure the rear bezel to the chassis.
4 Replace the four screws (#6-32x6) that secures the rear bezel to the top and bottom of the chassis.
5 Route the rear I/O accessibility lighting cable through the routing guides on the chassis.
6 Align and place the power-supply cover on the chassis.
7 Replace the four screws (#6-32x6) that secure the power-supply unit to the back of the chassis.
8 Insert the rear I/O accessibility lighting cable through the slot on the chassis.
9 Secure the rear I/O accessibility lighting cable to the chassis using the securing clip.
10 Connect the rear I/O accessibility lighting cable to the I/O board.
Post-requisites
1
Follow the procedure from step 7 to step 9 in
to replace the rear handle bar.
2 Replace the left and right side-panels. See “
”.
.
115
Содержание Area-51 Threadripper Edition R7
