DC UPS
1
INSTALLATION
FIXING THE TABS ON THE DC UPS
Caution
To install the DC UPS, turn off the AC power. Only connect after it is fixed and the
battery bank connected.
To attach the tabs to the DC UPS, loosen the side screws with the indicated wrench, position the tab and tighten
the screws by the DC UPS.
L - OUTPUT INDICATOR LED
Indicates that the outputs for equipment are in service.
M - GROUND CONNECTION
Place to connect the protective ground at the DC UPS. It is necessary to connect this conductor or connect
the ground through the AC input connector.
Attention
The connection to protective ground is mandatory. It can be connected through power cable or chassis
connection.
N - AC INPUT CONNECTION
Place for connecting the AC power cable.
O - AC PROTECTION FUSE
Caution
For replacing the AC fuse, please unplug the AC power from the DC UPS.
Attention
The AC fuse is 250VAC, your model must be seen according to the fuse table.
P - ETH
Ethernet port for network connection.
Q - RESET
Reset the Manageable DC UPS to the factory default setting IP 192.168.1.50 Username: admin Password:
admin.
Q - EXTERNAL TEMPERATURE
Connection of temperature sensor.
Nº 2
M3
The fixing tabs can be installed
at 0° or 90°.
F
B
