28
Adjusting the work surface
Move the work surface into the horizontal position to adjust the assembly table to the length of the mounting
panel. Remove the safety splint positioned at the lower pull out part. Then loosen the locking screw and
adjust to the desired length.
The locking screws must be tightened now and the safety splint must be put back.
Only two locking screws need to be loosened at the upper pull out part when adjusting to the required
length. Then tighten the locking screws again; the work surface is now adjusted to the length of the
mounting panel.
Now place the mounting panels onto the work surface.
Figure 7: AMTE250 retracted work surface
Figure 9: position of safety splint
Safety splint
Figure 8: manual control unit (similar)
