23
SAFETY INSTRUCTIONS
1. Do not overload the assembly table! Prior to any use, there should be a check that the prescribed
maximum load of 300 kg will not be exceeded.
2. During use, no one should remain sitting or standing on the assembly table.
3. Make sure that the loaded assembly table has been secured against unintended rolling.
4. Ensure that the load is evenly distributed over the assembly table's entire work surface.
5. The assembly table was designed for even, firm surfaces and is therefore not suitable for sloping,
uneven surfaces.
6. Loading and unloading should only be carried out in the horizontal position.
7. The assembly table is designed for indoor areas and is therefore not suitable for work outdoors.
8. The AMTE250 is not suitable for use in an environment where flammable or explosive gases or vapours
may occur.
9. AMTE250 operating mode: intermittent operation AB 2 min./18 min., that is max. 2 minutes operation under
nominal load, after which a pause of 18 minutes must be observed, Otherwise function failure may occur!
10. Safety class IP54 is only observed when the power pack unit ACCU AC 4.5 is connected to the control unit
CONTROL AC 4.5.
This appliance is not suitable for use by people with restricted physical, sensory or intellectual
abilities or those without experience and/or knowledge, unless they are supervised by a person who
is responsible for their safety or have received instructions from them on how to use the appliance.
!
SPECIFIED CONDITIONS OF USE
The AMTE250 is designed for the assembly and wiring of mounting panels up to max. 1100 x 1900 mm W x H.
EN
