ALFAtron ALF-MUH88E, Руководство пользователя

Страница: 12 / 44

ALFATRON ALF-MUH88E
7
3.3 Connection Procedure
1) Connect HDMI sources (e.g. DVD) to HDMI input ports of the Matrix Switcher via
good quality HDMI cables.
2) Connect the Pre-Installed CAT5e/CAT 6 cable infrastructure to Matrix Switcher
and HDBaseT receivers via good quality patch leads.
3) Connect HDTV to HDMI output port via HDMI cable.
4) Plug in an HDMI cable in to each of HDBaseT Receiver and connect to the local
display [HDTV].
5) Connect AVR amplifier to SPDIF output port or via the Toslink optic fibre cable.
6) Connect speaker to L&R (RCA) output port via audio cable.
7) Plug the IR Receivers 3.5mm jack into the IR IN sockets on HDBaseT Receivers
and plug in the IR Emitters to the IR OUT sockets (1~8) on Matrix Switcher to
make up as IR Matrix.
8) Plug the phoenix connector in to the RS232 socket on the matrix, this will enable
the Matrix Switcher to be controlled via a PC.
9) Plug in a Patch lead from the router in to the Ethernet port on Matrix Switcher to
control Matrix Switcher by TCP/IP protocol.
10) Plug in the power supply cord. Once all components have been connected and
the installation is completed, switch on the mains supply at the socket.
Note:
1. Connect HDBT ports of Matrix Switcher and far-end HDBaseT Receivers with
straight-through cable.
2. IR receivers connected to IR IN should be with carrier. If not, send
command %0900. or %0901.to activate native carrier mode or force carrier mode
in the IR matrix launched between Matrix Switcher and far-end HDBaseT Receiver.
3.4 Connection with HDBaseT Receiver
The Matrix Switcher features 7 HDBaseT outputs which support PoC technology. Plug
in the 7 RJ45 patch leads in to the HDBT outputs and connect to the pre-installed
infrastructure. Connect the HDBaseT Receivers to the pre-installed cabling via
additional patch leads. Plug the power supply in to the power socket on the matrix, the
HDBaseT Receivers will be powered by the Matrix Switcher.