Alfa Romeo Giulia 2019, Руководство пользователя

Страница: 161 / 212

159
NOTE:
Always reinstall the oil cap and tighten to
proper torque whenever it is removed to add
oil to engine. Never run the engine with cap
removed this could cause oil to leak from
engine.
Manual oil level checking procedure — 2.9L
Quadrifoglio
Check that the oil level is between the MIN
and MAX marks on dipstick, clean it with a
lint-free cloth and reinsert it. Extract the
dipstick again and check that the level is
between the MIN and MAX marks.
Top-up and oil level indication update on
display
If a engine oil top-off is needed, in order to
ensure the correct indication of the oil level
on the display, leave the car on flat ground
with the engine running for approximately
5 minutes (temperature higher than 176°F
(80°C)) and shut the engine off then proceed
with the process below:

2.0T 4 MAir — start the engine again and
idle it for about five minutes.

2.9L Quadrifoglio — Wait for five minutes,
turn the ignition to the ON mode without
starting the engine and wait for a few
seconds.
NOTE:
If you have added the specified amount of oil
and the indicator is not reading “Full”,
please contact you authorized dealer.
Engine Coolant Fluid
If the level is too low, unscrew the cap of
reservoir and add the fluid described in the
"Technical Specifications" chapter.
Washer Fluid For Windshield/Headlights
The windshield and headlights washer fluid
reservoir has a telescopic filler.
If the level is too low, remove reservoir cap
and lift the filler. Then, add the fluid
described in the "Technical Specifications"
chapter.
CAUTION!
Make sure not to add too much oil when
topping off the engine. Engine oil in
excess may damage the engine. Have the
vehicle checked. Never exceed the MAX
level when topping off engine oil. It is
advisable to check the oil level in
intermediate steps using the oil dipstick
(2.9L Quadrifoglio Only).
CAUTION!
The oil level is not refreshed immediately
on the display after topping off.
Consequently, wait for the oil level to be
refreshed on the display and follow the
procedure below.
WARNING!
If the engine oil is being topped up, wait
for the engine to cool down before
loosening the filler cap, particularly for
vehicles with aluminium cap (if equipped).
WARNING: risk of burns!
CAUTION!
The oil level must never exceed the MAX
mark.
If the MAX mark is exceeded MAX (last
notch on the right turns red) after the
fill-up, go to your authorized dealer as
soon as possible to have the oil in excess
removed.
Do not add oil with specifications different
from those of the oil already in the engine.
Used engine oil and oil filters contain
substances which are harmful to the
environment. To change the oil and filters,
we advise you to contact your authorized
dealer.
2019_ALFA_GIULIA_COMBINED_UG_USA.book Page 159