Alfa Romeo Giulia 2019, Руководство пользователя

Страница: 128 / 212

STARTING AND OPERATING
126
Deactivation
The system is deactivated and the set speed
is canceled if:

The button on the Adaptive Cruise
Control is pushed (with the system
enabled or paused).

The ignition is cycled to STOP.

RACE mode is activated.
The system is canceled (the set speed and
distance are stored):

When the system is paused (refer to the
“Activation / Deactivation” section).

When the conditions shown in the
“Setting The Desired Speed” section
occur.
Limited Operation Warning
If the dedicated message is shown on the
display, a condition limiting the Adaptive
Cruise Control operation may have occurred.
This could be due to an obstruction of the
vehicle’s sensor or camera. It could also be
due to a fault in the system. If an obstruction
is detected, clean the area of the windshield
opposite the interior rear view mirror, where
the camera is located, as well as the area of
the front bumper where the sensor is located.
Then check that the message has disap
-
peared.
When the conditions limiting the system
functions end, normal operation will resume.
Should the fault persist, contact an autho -
rized dealer.
Precautions While Driving
The system may not work correctly in some
driving conditions (see below). The driver
must control the vehicle at all times.
Vehicle Not Aligned
The system may not detect a vehicle trav -
eling in the same lane, in the same direction,
but is not aligned. It also may not detect a
vehicle which is cutting in from a side lane.
Sufficient distance from the vehicles ahead
may not be guaranteed in these cases.
The non-aligned vehicle can weave in and
out of the driving lane causing the vehicle to
brake or accelerate unexpectedly.
Steering And Curves
Driving on curves with the system set could
limit speed and acceleration to guarantee
vehicle stability, even if no vehicles are
detected ahead.
When leaving the curve, the system resets
the previously set speed.
Steering And Curves
NOTE:

In cases of narrow curves, the perfor -
mance of the system could be limited. In
this case, it is advisable to deactivate the
system.

The system only limits the speed DURING
a bend and not BEFORE it.
Using The System On Slopes
When driving on roads with a variable
incline, the system may not detect the pres
-
ence of a vehicle in the lane. System perfor -
mance could be limited according to speed,
load, traffic conditions and steep slopes.
2019_ALFA_GIULIA_COMBINED_UG_USA.book Page 126