Alfa Plam GRANDE 37, Инструкция по использованию, техническому обслуживанию и монтажу

Страница: 16 / 28

13
P5 Manual Standby Press and hold key for 3s to activate Standby mode

LED symbols:
Igniter Led ON: Igniter is active
Auger Led ON: Auger is active
Pump Led ON: Pump is active L3
Aux 1 Led ON: Aux 1 is active L4
Additional motor Led ON: Additional motor is active L5
Aux 2 Led ON: Aux 2 is active L6
Aux 3 Led ON: Aux 3 is active L7
Not active L8
Not active L9
Pellet level sensor Led ON: Out of pellet
Exterior thermostat Led ON: Contact is open
Sanitary water switch Led ON: Sanitary water required

Display:
-
Display:
o
Date and Time
o
Chrono Modality (D-Daily, W-Weekly, We-Week-End)
o
System Power (P1, P2, P3, P4 and P5)
o
Recipe (Pellet 1)
o
System Mode (Check Up, Ignition, Stabilization, Run Mode, Modulation, Standby, Safety, Extinguishing, Recover
Ignition, Block, Off)
-
Errors (Alarms):
If error (alarm) occurs, system switches to Block Mode.
Error Code
(Alarm Code)
Error (Alarm) Description
Er01 Safety Thermostat Activated
Er02 Safety Manometer Activated
Er03 Extinguishing due to low temperature of flue gases
Er04 Extinguishing due to high water temperature in the boiler
Er05 Extinguishing due to high temperature of flue gases
Er06 Safety thermostat on auger housing is activated
Er07 Encoder error. No signal
Er08 Encoder error. Unable to adjust number of revolutions
Er09 Low water pressure
Er10 High water pressure
Er11 Error due to problems with the internal clock
Er12 Extinguishing due to ignition failure
Er15 Power outage longer than 50 minutes
Chrono Enable
Summer-Winter
Set System Power
Recipe
Leds
Current water
temperature in the boiler
Set water temperature in
the boiler
Error Code (Alarm)
Maximum number of
operating hours achieved
Date and Time
System Mode