Alfa IN aXe 250 mobil GAS, Инструкция по эксплуатации

Страница: 23 / 30

23/30
ALFA IN a.s. © www.alfain.eu
6. By long-pressing the button V13 switch between voltage correction and
wire feed speed. By short-pressing this button switch between set
correction and choke value.
7. Set the voltage correction, wire feed speed or choke value by the encoder
V16 (if necessary).
8. Press the button V20 to switch between modes 2T / 4T / 2T stairs / 4T stairs .
9. In the mode 2T stairs / 4T stairs you cannot set the parameters during the
welding process.
10. If is connected the torch with remote control, on its display is shown
machine output (current, fire feed speed, material thickness), correction
(voltage, wire feed speed) or choke value. With buttons
H6 (UP) and H7
(DOWN) set the displayed value, with the button MODE switch between
functions. If is activated the JOB choice by the remote control, you can
switch between JOBs.
9. PULSED MODE
(does not apply to aXe 250 MOBIL GAS and aXe 320 MOBIL GAS)
1. With the button
V2
switch on the pulsed mode (only at stated synergic
programs).
2. If is the pulsed mode switched on, LED V3 at the button V2 shines.
3. Left display V10 shows machine output (current, wire feed speed, material
thickness), right display V11 shows voltage value. Correction value
(voltage, wire feed speed) is displayed on the dispay V11 only when you
setting.
4. By pressing the button V8 can change the machine output screening
(current, wire feed speed, material thickness).
5. Set the machine output (current, wire feed speed, material thickness) by
the encoder V5 .
6. In the calibration menu you can set the choice of turning off correction
zeroing at the change of the machine output value.
7. By long-pressing the button V13 switch voltage correction and wire feed
speed.
8. Set the voltage correction or wire feed speed by the encoder V16 (if
necessary).
9. Press the button V20 to switch between modes 2T / 4T / 2T stairs / 4T stairs .
10. If is connected the torch with remote control, on its display is shown
machine output (current, fire feed speed, material thickness), correction
(voltage, wire feed speed). With buttons
H6 (UP) and H7 (DOWN) set the
displayed value, with the button MODE switch between functions. If is