27/30
ALFA IN a.s. ©
www.alfain.eu
6. Troubleshooting and repairing of the aXe welding equipment should only
be carried out only by suitably qualified or competent person.
7. A ‘competent person’ must be a person who has acquired through training,
qualification or experience, or a combination of them, the knowledge and
skills enabling that person to safely carry out a risk assessment and repairs
to the electrical equipment in question.
8. The person carrying out the servicing needs and repairs must know what
to look at, what to look for and what to do.
OPERATIONAL SAFETY INSPECTION OF THE MACHINE ACCORDING TO
ČSN EN 60 974-4
Prescribed operations of tests, procedures, and required documentation are
listed in ČSN EN 60974-4. SERVIS
ERROR MESSAGES
The left display
V10
shows Err, the right display
V11
shows number / marking of
the error.
Err 1
Overheating of the machine. DO NOT POWER OFF THE
MACHINE!
Err noP
Pulsed mode cannot turn on for the selected synergic program.
Err noS
Pulsed mode cannot turn off, synergic program in only for the
pulsed mode.
TROUBLE SHOOTING
Symptom
Reason
Solution
The torch is too
hot.
Nozzle is not fixed.
Tighten the nozzle.
Button on the
torch does not
respond.
Connectivity of EURO
connector is loose.
Tighten EURO
connector.
Damaged wiring in the
torch.
Check and replace if
necessary.
Irregular wire feed
or wire is caked to
the nozzle.
The wire on the spool is
too tightly wound.
Check and replace the
spool if necessary.
The ball is fused to the
nozzle.
Cut out the ball and piece
of the wire at the
beginning.
Irregular or no
wire feed.
Poor pressure in the
wire feed rolls.
Adjust the pressure
according to this
instruction manual.
The torch is damaged.
Check and replace if
necessary.
