13
1. If the AUTO mode is not comfortable , you may manually override the settings by using COOL, DRY,
HEAT(HEAT PUMP units only), or FAN ONLY modes.
2. Push the TEMP button to set the desired room temperature. When in COOLING mode, the most
O
comfortable settings are 21 C/70 F or above. When in HEATING mode, the most comfortable settings
o
O
are 2 8 C/82 F or b
elow.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
4. Push the ON/OFF button. The operation lamp lights and the air conditioner starts to operate per your
settings. Push the ON/OFF button again to stop this unit operation.
COOL , HEAT, and FAN ONLY Operation
1. Push the MODE button to select DRY.
O
o
O
2. Push the TEMP button to set the desired temperature from 21 C/70 F to 28 C/82 F.
3. Push the ON/OFF button. The operation lamp lights and the air conditioner starts to operate in
the DRY mode. Push the ON/OFF button again to stop this unit operation.
DRY OPERATION
TIMER ON button can set the auto-on time of the unit. TIMER OFF button can set the auto-off time of the unit.
TIMER Operation
1.1 Push the TIMER ON button, then the remote controller shows TIMER ON , the last set time for the
starting operation and the signal "h" will be shown on the DIGITAL DISPLAY area. You are now ready
to reset the time to START the operation.
1.2 Push the TIMER ON button again to set desired unit start time.
1.3 After setting the TIMER ON ,there will be a one-half second delay before the remote controller transmits
the signal to the air conditioner. Then, after approximately another 2 seconds, the signal "h" disappears
and the set temperature will re-appear on the digital display.
1. To set the starting time.
NOTE:
The FAN ONLY mode cannot be used to control the temperature. While in this mode, only steps 1
3 and 4 may
be performed.
2. To set the stopping time.
2.3 After setting the TIMER OFF ,there will be a one-half second delay before the remote controller transmits
the signal to the air conditioner. Then, after approximately another 2 seconds, the signal "h" disappears
and the set temperature will re-appear on the digital display.
2.2 Push the TIMER OFF button again to set the time you want to stop the operation.
2.1 Push the TIMER OFF button and the remote controller will show TIMER OFF, the last set time for
the stopping operation and the signal "h" will be shown on the DIGITAL DISPLAY area. You are now
ready to reset the time of the STOP operation.
3. Set the starting & stopping time
3.1 Push the TIMER ON button, the remote controller will show TIMER ON, the last set time for START
operation and the signal "h" will be shown on the DIGITAL display area. You are now ready to readjust
the TIMER ON to start the operation.
3.2 Push the TIMER ON button again to set the time you want to start the operation.
3.3 Push the TIMER OFF button, the remote controller will show TIMER OFF, the last set time for STOP
operation and the signal "h" will be shown on the DIGITAL display area. You are now ready to reset the
time to STOP operation.
3.4 Push the TIMER OFF button again to set the time you want to stop the operation.
3.5 After setting the TIMER, there will be a one-half second delay before the remote controller transmits the
signal to the Air Conditioner. Then, after approximately another 2 seconds, the set temperature will
re-appear on the digital display .
NOTE
1. Please reset the TIMER after cancelling the former time settings.
2. The setting time is relative time. That is the time set is based on the delay of the current time.
Содержание MPF-12CR
Страница 17: ......
