Alen MPF-12CR, Руководство пользователя

Страница: 13 / 17

11
Model
Environment
Reaching Distance
Signal Range
Lowest Voltage of CPU
Emitting Signal
Rated Voltage
R51H, R51H/C
O O
-5 C 60 C(-41 F~140 F)
8m
3.0V
2.0V
~ ~
Remote Controller Specification s
Performance Feature
Introduction of Function Buttons on the Remote Controller
1. Operating Mode: COOL HEAT DRY FAN and AUTO.
2. Timer Setting Function in 24 hours.
O O
3. Indoor Setting Temperature Range : 17 C~30 C.(63 F ~86 F)
4. LCD (Liquid Crystal Display) of all functions.
5. Control function of charactron tube
SET TEMPERATURE( /F )
AUTO
COOL
DRY
HEAT FAN
HIGH
MED
LOW
TEMP
MODE
FAN
SPEED
Fig. 1
TIMER
OFF
LOCK RESET
ON/OFF
TIMER
ON
C
1
2
8
3
4
6
5
7
9
TEMP Button : Push the button to decrease the indoor temperature setting.
MODE Select Button: Each time you push the button, a mode is selected in a sequence
that goes from AUTO COOL DRY HEAT and FAN, as the following figure:
NOTE: HEAT only for Heat Pump
AUTO COOL DRY HEAT FAN
1
2
RESET Button: When the RESET button is pushed, all of the current
settings are cancelled and the control will return to the initial settings.
3
LOCK Button: Push this button to lock in all the current settings.
To release settings, push again.
4
5
TIMER ON Button: Press this button to preset the time ON(start to operate).
Each press will increase the time ON setting in 30 minutes increments.
When the setting time displays 10:00, each press will increase the time ON
setting in 60 minutes increments. To cancel the time ON program, simply
adjust the time ON to 0:00.
6
TIMER OFF Button: Press this button to preset the time OFF (turn off the operation).
Each press will increase the time OFF setting in 30 minutes increments. When the
setting time displays 10:00, each press will increase the time OFF setting in 60 minutes
increments. To cancel the time OFF program, simply adjust the time OFF to 0:00
ON/OFF Button: Push this button to start the unit operation, push the button again to stop the unit operation. 7
FAN SPEED Button: This button is used for setting Fan Speed in the sequence that goes from AUTO LOW
MED to HIGH, then back to Auto.
8
TEMP Button : Push the button to increase the indoor temperature setting.
9