Alean AL-238P, Руководство по установке

Страница: 11 / 29

AL-238
PPROGRAMMING GUIDE
11
Part 2 System Operation Instruction
1.User operation guide
1.1 .Arming
Keypad arming: password(123456) + “ARM ” key
Remote controller arming: Press“ ”key
After right operation, control panel sounds di…di…di…, wait till control panel delay arming time is up(10s), and the arming
succeeds.
1.2.Disarming
Keypad disarming: password(123456)
＋
"disarming " key
Press remote control disarming
：
“ ”key
Keypad buzzer sounds once, the alarm enters disarming status.
1.3.Quick arming
Keypad quick arming: "ARM" key for 3sec or more, control panel buzzer sounds
di…di…di…, wait until control panel delay arming time is up, and succeeds. (
voice hint till delay arming ends).
Note: this function requires turn on “Quick arming”, for programming, please refer to "Command 13" in the programming table of
the user manual
1.4.Stay arming
Keypads stay arming: password(123456) + "stay” key
Press remote control stay arming: “ ”key, control panel starts sound di…di…di…,
wait till delay time is up, control panel arming succeeds. ( voice hint till delay
arming ends).
Staying arming mode, when there is a zone set to the home zone, adapting Stay Arming, all of home zones are invalid, which
means they are in disarming status, only effective when are not home zone.
1.5.Single zone arming and disarming(For 1-8 zone)
”bypass” key
，
when enter the single zone arm and disarm programming state, press the “zone number” + “arm or disarm
“key, you can arm or disarm the corresponding zone, press * to exit the programming state;
1.6.Duress disarming:
Keypad operation: seized & held pa"disarming " key, control panel disarms and report to receiver to tell Duress alarm.
1.7.Enter / exit programming instructions
Enter programming——password
（
123456
）
+#
；
Exit programming—— “*”key
；
1.8.Eliminate alarm
Keypad operation: password(123456)
＋
"*" key (can remove voice, linkage, siren, display)
1.9.Query alarm record
Enter the password ( 123456)) +#, enter the programming, and then enter 00+01, the panel broadcasts the latest alarm record,
press the “1” key to query the previous alarm record, press the “2 “key to query the next alarm record, and press the “0 “key to
repeat to broadcast once, press “*# “to exit the query.
If you need to query information such as "Operation Record", "System Version", "System Time" and "GSM Antenna Signal Value",
please refer to "Command 00" in the programming table of the user manual;