Alcorn Mcbride V+ series, Руководство пользователя

Страница: 103 / 276

Event Reference 5-21
E
ve
n
t
Ref
er
en
ce
Example
Event Data1 Data2 Data3 Data4
PutVar Port3 2 SlaveShowVar ShowVar
Sets "SlaveShowVar", located in a remote Show Controller connected to Port3, equal to
the value of "ShowVar", a local State Variable.

DMXRamp
Sets a DMX dimmer to a given value over a given period of time.
Event Syntax
Event Data1 Data2 Data3
DMXRamp Channel
Number
(1-512) Final Value* Optional Ramp Duration**
*Final Value can be in Percent (0% - 100%), Decimal (0 - 255) or Hex (h00 - hFF).
**The Ramp Duration should be in Minutes:Seconds.Frames (e.g. 03:04.15) and can
have a maximum value of 65535 frames (36:26.20 max @ 29.97 and 30 fps; 45:30.15
max @ 23.976 and 24 fps; 43:41.10 max @ 25 fps). If no ramp duration is entered, the
channel is immediately set to the final value.
Example
Event Data1 Data2 Data3
DMXRamp 250 35% 02:06.15
Ramps DMX channel 250 to 35% brightness over a period of two minutes, six seconds,
and fifteen frames.

Break
– (New in version 6.35)
Sends a Break on the specified serial port. Break is not “queued”, so wait until
all previous data has finished transmitting before it is issued. Special warning:
Since frame 0 and 1 of a sequence are really the same, and since serial messages
are synchronized using a one frame delay, if you put a Msgout at frame 0 and a
Break at frame 1, the break will actually occur first! A standard SMPTE break is
17-21 bits at the current data rate. At 38.4K baud this corresponds to a Data2
value of 2. For 9600 baud use a value of 8.
Event Syntax
Event Data1 Data2 Data3 Data4
Break Name of Port Duration of break in
multiples of 250 usec