Alcohol Countermeasure Systems Alcolock LR, Инструкция по установке и обслуживанию

Страница: 64 / 72

ALCOLOCK LR 59
24.3 SIGNS OF TAMPERING -- EVENT LOG
The below table lists interlock events that are associated with tampering. If any
interlock event appears in the event log, the client must fill out an occurrence
report that provides an explanation for that event.
For more information refer to the ALCOLOCK LR compliance manual and
troubleshooting manual.
ATTENTION!
•
Any signs of tampering must be detailed in the Tamper Report (refer to
Appendix 1 in this manual)
•
Tampering is not limited to these areas. Inspect the entire ALCOLOCK LR
device
EVENT
(WITH RECALL NUMBER) DESCRIPTION
WHERE TO INSPECT
Extended missed retest (5)
or failed retest (6)
Failure to respond to
a Retest or Pull Over,
Turn Off Engine message
within the set time limit.
Inspect the alarm horn and
all associated wiring for
cuts or removed seals.
Short (8) or long (14) power
interrupt
Vehicle battery was
disconnected (refer to
compliance guide).
Inspect wires that are
connected from the ECU to
the ground, and to the main
power source.
NOTE: If the battery was
disconnected, there may
not be any visible signs of
tampering.
Start Violation (7) Vehicle was started without
passing a breath test (hot
wiring, push starting).
Inspect the starter wires for
cuts at or around the seals.
NOTE: (For manual
transmissions) The vehicle
may have been push
started, in which case there
may be no visible sign of
tampering.