Alcohol Countermeasure Systems Alcolock LR, Инструкция по установке и обслуживанию

Страница: 27 / 72

INSTALLATION MANUAL 22
NO OBD
For vehicles not connected to OBD-II, and instead
connected to a direct tach source under the hood.
3. After the correct option has been selected, based on the
vehicle and installation type, press OK.
Read only one of the following sections of this manual,
based on the step 2 selection:
•
OBD / TACH – section 16.2.1
•
OBD / SPEED – section 16.2.2
•
NO OBD – section 16.2.3
16.2.1 OBD / TACH
NOTE: Read this section for non-hybrid vehicles where the
tach was obtained through OBD-II.
After selecting the OBD / TACH option in the previous
screen, TACH is displayed, along with the following:
•
Idling – the vehicle engine rpm reading
NOTE:
•
If the idling rpm reading is lower than the Idle Point
rpm value on the second line, Stopped will be displayed
instead of Idling.
•
If the Idling rpm reading is higher than the Run Point
rpm value on the third line, Running will be displayed
instead of Idling.
•
If the rpm reading on the first line is not set to Idling,
check ECU OBD-II connection.
•
If the problem continues, obtain the tach signal from
a location under the hood. Refer to section 13.0 and
14.6 of this manual. The ECU and HS may need to be
exchanged.
•
Idle Point – a preset rpm threshold value
•
Run Point – a preset rpm threshold value
NOTE: The initial Idle Point and Run Point values may vary,
depending on the vehicle.
OBD SELECT
NO OBD
Exit
OK? Select
OBD SELECT
TACH
Exit
OK? Select
Idling 00960
Idle Point: 00780
Run Point: 02400