Alcohol Countermeasure Systems Alcolock LR, Инструкция по установке и обслуживанию

Страница: 58 / 72

ALCOLOCK LR 53
NOTE: The initial Idle Point and Run Point values may vary,
depending on the vehicle.
1. Check that the Idling rpm reading reflects the reading on
the dashboard rpm gauge.
2. If the Idling rpm reading is acceptable, press Set Tach to
reset the rpm thresholds.
NOTE: After Set Tach is pressed, the Idling rpm reading (on
the first line) is used to reset the Idle Point and Run Point tach
thresholds (the second and third lines).
TACH is displayed, along with the following:
•
Idling – the vehicle engine rpm reading
•
Idle Point – reset to 0.5 x the Idling engine rpm
•
Run Point – reset to 1.5 x the Idling engine rpm
Next is displayed at the bottom-left of the screen.
3. If the tach thresholds are correct, press Next (otherwise
press Set Tach until a correct tach threshold is obtained).
After Next is pressed, ACCELERATE is displayed, along
with the following:
•
Idling – the current engine rpm
•
Idle Point – the reset rpm threshold value
•
Run Point – the reset rpm threshold value
ATTENTION! Ensure that the vehicle is in the park / neutral position, with parking
brake engaged, to prevent the vehicle from moving.
4. Press the accelerator pedal and steadily increase the
engine rpm to a point slightly above the Run Point rpm
threshold value on the third line. (This is to validate the
Run Point rpm threshold value that was reset in step 3.)
REMOVAL
TACH
Exit
OK? Set Tach
Idling 00960
Idle Point: 00780
Run Point: 02400
REMOVAL
TACH
Exit
Set Tach
Idling 00960
Idle Point: 00480
Run Point: 01440
REMOVAL
TACH
Exit
Next Set Tach
Idling 00960
Idle Point: 00480
Run Point: 01440
REMOVAL
ACCELERATE
Exit
Idling 00960
Idle Point: 00480
Run Point: 01440