Alcohol Countermeasure Systems Alcolock LR, Инструкция по установке и обслуживанию

Страница: 15 / 72

INSTALLATION MANUAL 10
•
Use supplied heat shrinks or tamper resistant labels on all solder connections.
Refer to section 20.0 of this manual
•
Use supplied tie wraps to neatly incorporate wires into the vehicle wire
loom. Keep wires away from vehicle components that move, or that become
excessively hot
14.1 ECU CABLE-WIRE SUMMARY
The following table lists the wires from the ECU cable (13-001102), for basic
reference.
NOTE: Refer to Appendices 3 and 4 at the back of this manual for wiring diagrams
(with and without the external relay).
WIRE # COLOUR CONNECTED TO:
1 Red +12 volt or +24 volt (main power)
8 Black Ground
3 White Ignition (+12 volt or +24 volt, switched on position only)
2 Green Tachometer
4 Blue-White CAN-Low (CAN-)
5 Yellow-Red CAN-High (CAN+)
10 Blue-Yellow Starter (coming from the ignition switch)
9 Light Blue Starter (going to the starter)
12 Orange Alarm horn + (positive)
13 Brown +12 volt (main power)
Retest flasher (hearing-impaired)
WIRE #
COLOUR CONNECTED TO:
6 Pink 12 Volt Red wire on alcohol interlock ECU cable
11 Violet Red wire of the alarm flasher
14.2 ECU WIRE-CONNECTION STEPS
1. Prepare the ECU wires using the wire strippers, expose 1/2” of the ECU
wires.
2. Place the supplied heat shrinks over all wires in the table below, except ECU
wires 1 (Red), 8 (Black) and 3 (White).
79-000252
•
Wire 9 (Light Blue)
•
Wire 10 (Blue-Yellow) x2
79-000251
•
Wire 2 (Green)
•
Wire 12 (Orange)
•
Wire 13 (Brown)