Alcohol Countermeasure Systems Alcolock LR, Инструкция по установке и обслуживанию

Страница: 33 / 72

INSTALLATION MANUAL 28
Ready for Test is displayed along with the client’s last
name.
The HS install procedure and ITE install transaction are
complete. Continue to the next section.
17.0 POST-INSTALLATION TESTING
After the HS install procedure and ITE install transaction are complete, insert a
new mouthpiece and provide an accepted breath test. With the vehicle in park or
neutral, turn on the vehicle engine for a short period.
NOTE: Refer to the instruction manual for more information about using the
ALCOLOCK LR device.
18.0 ATTACHING THE SECURITY ENCLOSURE
Attach the security enclosure only after doing the following:
•
Connecting the ECU, alarm horn and alarm flasher wires (if required)
•
Performing an HS install and ITE transaction
•
Performing post-installation testing
The security enclosure assembly (79-007620) is attached to the cable connector
opening of the ECU, to prevent tampering with the cable connections.
The security enclosure assembly consists of the following:
•
Rear clip (58-000529)
•
Front clip with brass insert (58-000527)
•
Screw (45-000129)
•
Plastic plug (58-000528)
•
Tamper-proof label (65-000070)
1. With the top of the ECU face-forward (as shown), attach
the front clip (58-000527) by aligning the grooves of the
clip with the ridges of the ECU
1 2
.
2. Fit the ECU and HS cable
3
4
onto their slots at the top
of the clip.
NOTE: Ensure that the brass screw insert
5
of the front clip
is not covered by wires.
Ready for Test
Name
Hold for Menu
1 1
2 2
3 4
5